The
JBL® Club A600 mono subwoofer amplifier delivers
600 watts RMS using a
Class D amplifier design to ensure high power and minimal current draw. Its
speaker-level inputs allow this amplifier to be integrated into almost any system, even one using your car's factory-installed radio. The
low-pass filter and
variable bass boost can be used to maximize the performance of your subwoofer and enclosures, while a
phase switch
Features:
- Compact Design: The JBL® Club A600 amplifier features a low-profile chassis and a small overall footprint to fit into even more vehicles with limited space.
- High and Low-Level Inputs: Speaker-level and low-level inputs allow the Club A600 to be integrated into most factory-installed or aftermarket stereo systems.
- Variable Crossover and Bass Boost: Unlike many other amplifiers available at similar price points, the JBL® Club A600 features variable electronic crossovers and bass boost circuits, allowing for precise system tuning and performance.
- Low Noise and Low Distortion: The Club A600 was developed with balanced differential inputs to ensure low noise and low distortion even at high output levels. This also makes it significantly less susceptible to line-induced radiated engine noise.
- Input Level Control: When using low-level inputs, this control adjusts the input sensitivity between 200 mV RMS and 2.0 V RMS. When using high-level inputs, this control adjusts the input sensitivity between 2 V RMS and 20 V RMS.
- Full Integrated Protection: Integrated circuitry protects the Club A600 from short circuits, over-temperature, as well as over and under-voltage. The LED indicator shows when one of these conditions is present.
- Phase Switch: This switch changes the inversion of the input phase between inverted and non-inverted. This is particularly helpful for system optimization, based on the enclosure type and placement in the vehicle.
- RBC Wired Remote Control: The wired RBC remote control is easy to install and can be mounted for convenient volume adjustment from the driver's seat.
- Class D Amplifier Technology: The JBL® Club A600 mono subwoofer amplifier delivers 600 watts RMS using a Class D amplifier design to ensure high performance and minimal current draw.
- Turn-On Mode: This "Turn-On Mode" switch changes from DC to REM to switch between low and high-level signals. This is particularly helpful with a remote turn-on wire. A selectable "Turn-On Mode" can protect the battery from draining if the amplifier is not turned on for a while.
Technical Specifications:
- 350 Watts RMS x 1 at 4 Ohms (600 Watts RMS x 1 at 2 Ohms)
- Class D amplifier technology
- Variable low-pass filter (32–320 Hz, 12 dB/octave)
- Variable bass boost (0–12 dB at 45 Hz)
- Phase switch (0, 180 degrees)
- Preamp and speaker level inputs
- Fuse rating: 30 A x 2
- 8.34 mm (8 AWG) power and ground wires recommended – wiring and hardware not included with amplifier
Delivery Contents:
The scope of delivery includes the following parts:
- Club A600 Mono Subwoofer Amplifier: 1 piece
- 30-A ATO Fuses: 4 pieces (2 installed, 2 spare fuses)
- Bare Wire to RCA Adapters: 2 pieces
- Bass Level Remote Control Module: 1 piece
- 5 m Remote Control Cable (RJ-25 connector on both ends): 1 piece
- Self-tapping Screws for Remote Control (M3 x 15 mm): 2 pieces
- Mounting Screws (M4 x 53 mm): 4 pieces
- Owner's Manual: 1 piece
- JBL® Stickers: 2 pieces
Note: If possible, by selecting the desired parts and their quantity (top right next to the "Add to Cart" button),
